DSC LTE Universal Cellular Only Alarm Communicator 3G (HSPA/HSPA+)

DSC LTE Universal Cellular Alarm Communicator 3G uses LTE cellular networks for high-speed, reliable, and low-cost communication to compatible alarm systems and control panels. 

Alarm signals are directly transmitted to the IP Linecard of the monitoring station receiver without the need for extra involvement which saves time and eliminates potential points for failure. 

HOW IT WORKS

The device is installed between a telephone connection of a control panel and a telephone line. 

In a primary role, the communicator sends the alarm transmission over the network for a quick and easy response. 

When used as a backup, the communicator added the connection to the PSTN phone line. If this fails, it will connect to a cellular network to send an alarm signal to the monitoring station. 

EASY INSTALLATION 

The LE4000 can be installed and activated through the mobile or web interface included by C24 Communications, it does not require special tools or a complicated setup. 

ADAPTABLE IN CASE OF EMERGENCIES

This setup typically uses an LTE cellular network, but can automatically switch to 3G if LTE is not available, lessening the risk of connection failure. The panel transmission monitor can also switch from PSTN to cellular if needed.

EASY USER CONTROL

Users can view the communicator's status directly via their smartphones for on-site or remote troubleshooting. SMS command and control for panel arming and disarming is also an option. There are also two unique trouble display models available.

DSC LE4000-RG LTE Universal Cellular Alarm Communicator 3G features: 

• Uses LTE cellular network for high-speed, reliable and low-cost communications to an IP receiver 
• Automatically switches to 3G (HSPA/ HSPA+) if LTE service is not available 
• Compatible with control panels that communicate using the Contact ID and SIA (300 baud) formats 
• Full event reporting 
• 2 on-board inputs, 2 on-board outputs (open collector) 
• Activation and initialization via website or mobile interface available through C24 Communications
• View communicator status directly from your mobile phone to support on-site or remote troubleshooting 
• PTM (Panel Transmission Monitor) switches from PSTN to cellular on unsuccessful communication attempts
• SMS command & control for panel arm/disarm
• PTM call routing to direct cellular signals to multiple receivers based on dialed number 
• Advanced carrier selection to secure a suitable cellular connection
• Two unique trouble display models 
• Compatible with Sur-Gard System I-IP/II/III/IV/5 monitoring station receivers